Maintenace
The space requires minimal maintenance but the items detailed below are required. Use the Blog:Maintenance to log maintenance activities.
Report all findings, issues, questions, and concerns to the makerspace Board of Directors
Item | Frequency | Notes | |
Trash | Weekly | Dumpster is located outside the back of Unit 1. Please do not leave any food trash inside the office. Take it directly to the dumpster | |
Front Door | Weekly | Confirm door/lock are in good condition. Sweep Entrance | |
HVAC | Twice per year | There are 3 HVAC zones in the space see details below | |
Bathroom | Monthly | Check for Leaks Clean sink & toilet Replenish toilet paper & towels | |
Back Doors | Weekly | Confirm no items blocking the fire exit **Confirm no items blocking the fire exit Make sure the back door fire exit is not blocked | |
Roll Up Doors | Weekly | Confirm roll up chain is not binding | |
Back Shops | Weekly | Vacuum & Sweep sawdust and debris | Confirm dust collectors are not full |
HVAC Details
There are 2 HVAC zones in the space:
Unit 1
- Thermostat Controls both Heating & Cooling to the office space
- The unit is located above the bathroom.
Unit 2
- Thermostat Controls both Heating & Cooling to the classroom only. The unit is located above the bathroom.
Shop
- Unit 1 furnace provides heat only only to the wood shop.
- Unit 2's furnace has been disabled.
Electrical
- Unit 1
- Circuit Breakers are located in the utility closet and the wall of the woodshop
- Unit 2
- Circuit Breakers are located in the front segment of the Metal shop
Fire Protection
Fire Code compliance
Fire Extinguishers: There are seven wall mounted fire extinguishers for the space:
- Unit 1:
- Front lobby by kitchenette
- Woodshop by office door
- Woodshop on pillar by SawStop
- Woodshop by rear walk-in door
- Electronics Room near Laser (C02)
- 3d Printing Room by door