Difference between revisions of "Dremel Micro 8050"
(Created page with "{{Template:Equipment |owner=Jay Dellinger |serial=Serial Number |model=Dremel Micro 8050 |arrived=12/31/2014 |doesitwork=It works! |contact=Jay Dellinger |where=Workstation #3...") |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Template:Equipment | {{Template:Equipment | ||
|owner=Jay Dellinger | |owner=Jay Dellinger | ||
| − | |serial= | + | |serial=F013805000 |
|model=Dremel Micro 8050 | |model=Dremel Micro 8050 | ||
|arrived=12/31/2014 | |arrived=12/31/2014 | ||
| Line 19: | Line 19: | ||
* Use the included collet wrench to tighten/loosen collet for changing bits. | * Use the included collet wrench to tighten/loosen collet for changing bits. | ||
* Make sure bits are secure before using. | * Make sure bits are secure before using. | ||
| − | * Consult the instruction manual for | + | * Consult the instruction manual below for recommended speeds for different materials. |
== Safety == | == Safety == | ||
| Line 28: | Line 28: | ||
== References == | == References == | ||
| − | * | + | * [[Media:Dremel_micro_8050.pdf]] |
Latest revision as of 10:59, 31 December 2014
- Owner/Loaner: Jay Dellinger
- Serial Number: F013805000
- Make/Model: Dremel Micro 8050
- Arrival Date: 12/31/2014
- Usability: {{{usagerestrictions}}}
- Contact: Jay Dellinger
- Where: Workstation #3
Info
This is a brand new Dremel Micro 8050. There is a small box of bits for it next to the charging base. The tool should be stored on the charging base when not in use.
Permissions
- For general use by members.
- Treat equipment as if it were your own and put away as or better than you found it.
Basic Instructions
- Use the included collet wrench to tighten/loosen collet for changing bits.
- Make sure bits are secure before using.
- Consult the instruction manual below for recommended speeds for different materials.
Safety
- Keep loose hair and sleeves away from all moving parts.
- Bits and workpieces will be hot from friction after using
- Wear safety glasses when using this tool
